Bushing driver instructions

the driver is flush with the bottom of the spindle eye. Remove driver. (For Lip Seal Installation tips see Tech Tip # 01 ) c. Hold spiral steel bushing in hand, tilted slightly, and twist the spiral bushing into the spindle eye turning the bushing clockwise. d. Install it as far as you can by hand, and then use a T-handle tool (usually.  · For removing and installing bushings from 3/8 in. thru /8 in. diameter. Includes three sizes of drivers and multiple adapters. Lifetime warranty on tools. Includes step-by-step usage instructions and photos showing the tool in use. Instruction sheets are laminated to resist staining and are permanently fastened to the case. Replacement Hinge Pin Kit on Amazon - www.doorway.ru Along Tool \ Cable Puller on Amazon - www.doorway.ru video walks through the p.

bushing (B) Fig. 15 using the 24mm open end wrench supplied. 4. Slide the magnetic nail guide (A) Fig. 15 off of the driver blade. 5. Place both the magnetic nail guide and bushing in the carrying case for safe storage. 6. Take the standard nail guide (A) Fig. 19 and guide bushing (B) from the carrying case. 7. L Bushing Tool Instructions Poster L Preventive Maintenance Guide L Alignment Procedure L Comprehensive Warranty Statement L TRI-FUNCTIONAL® Bushing Replacement Tool Parts List L Bushing Tube Spacer Inspection/Replacement Procedure L Replacement Bushing Tube Spacer Orientation T TRI-FUNCTIONAL® Bushing Tool Information. Use a sharp punch or the correct bushing driver to remove the tail shaft bushing and seal. Step 2: Install the new bushing with a suitable driver. Step 3: Drive the new bushing flush with the inner bore of the housing as shown. Step 4: Drive a new seal into place. Almost any driver larger than the seal works for this purpose. Step 5.

Installation Tool for [B], [C], [D]. Also for use with Sure Cure [SC-E4OD] and Performance Pack [HP-4R]. Heavy Duty Transmission Universal Front Pump Remover. Z Slide Hammer / Seal Removal Tool. Z Input Clutch Housing Spring Compressor Tool. View our drill bushing guide for installation technical data. If a hammer is the only tool available, do not strike the bushing directly or it could.